 |
|||
|
|
|||
|
Page Title:
GOVERNOR REPLACEMENT - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-386-24-1-2
0326 00
GOVERNOR REPLACEMENT (Contd)
7.
Remove clip (1) from sleeve (3).
8.
Using soft-jawed pliers, rotate sleeve (3) back and forth to break loose O-ring (5).
9.
Using soft-jawed pliers, slide sleeve (3) into cylinder head (2).
10.
Remove retaining ring (9) and pin (6) from clevis (8) and link (4). Discard retaining ring (9).
11.
Remove O-ring (5) from sleeve (3). Discard O-ring (5).
CAUTION
Use care not to damage fuel injector control linkage when
removing governor.
12.
Remove
three screws (15), washers (16), governor (7), O-ring (10), and three sleeves (17) from front
housing
(11). Discard O-ring (10).
13.
Remove
inlet fitting (18) and check valve (20) from governor (7). Discard check valve (20).
14.
Remove
O-ring (19) from inlet fitting (18). Discard O-ring (19).
15.
Remove
outlet fitting (12) and check valve (14) from governor (7). Discard check valve (14).
16.
Remove
O-ring (13) from outlet fitting (12). Discard O-ring (13).
0326 00-4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version