 |
|||
|
|
|||
|
Page Title:
FUEL INJECTION CONTROL LINKAGE MAINTENANCE - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-386-24-1-2
0320 00
FUEL INJECTION CONTROL LINKAGE MAINTENANCE (Contd)
WARNING
Diesel fuel is flammable. Do not perform fuel system procedures
near open flame. Injury to personnel may result.
REMOVAL
1.
Remove clip (1) from sleeve (3).
2.
Using soft-jawed pliers, rotate sleeve (3) back and forth to break loose O-ring (5).
NOTE
Ensure no nicks or scratches occur to sleeve while sliding sleeve
into cylinder head. Damage to sleeve may result in governor not
sealing properly.
3.
Using soft-jawed pliers, slide sleeve (3) from governor (8) into cylinder head (2).
4.
Remove retaining ring (9) and pin (6) from clevis (7) and link (4). Discard retaining ring (9).
5.
Remove O-ring (5) from sleeve (3). Discard O-ring (5).
CAUTION
Fuel injector springs must be compressed to allow free movement
of the injector rack. Failure to do so may result in damage to fuel
injectors.
6.
Remove four screws (10), and lift fuel injection control linkage (11) from cylinder head (2) and fuel
injector control arms (12) from fuel injector control racks (13).
0320 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version