 |
|||
|
|
|||
|
Page Title:
EXHAUST MANIFOLD REPLACEMENT - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-386-24-1-2
0317 00
EXHAUST MANIFOLD REPLACEMENT (Contd)
REMOVAL
1.
Remove four studs (6) from exhaust manifold (5).
2.
Bend tabs of five retaining rings (2) and remove ten screws (1) and five retaining rings (2) from
exhaust manifold (5) and cylinder head (4). Discard retaining rings (2).
3.
Bend tabs of retaining ring (7) and remove two screws (8), retaining ring (7), exhaust manifold (5),
and three gaskets (3) from cylinder head (4). Discard gaskets (3) and retaining ring (7).
INSTALLATION
1.
Apply antiseize compound on ten screws (1) and two screws (8).
NOTE
Place screws in upper holes to support exhaust manifold and
gaskets.
2.
Position three new gaskets (3) and exhaust manifold (5) on cylinder head (4) with three new
retaining rings (2) and six screws (1). Do not tighten screws (1).
3.
Install two new retaining rings (2) and four lower screws (1) on exhaust manifold (5) and cylinder
head (4). Do not tighten screws (1).
4.
Install new retaining ring (7) and two screws (8) on exhaust manifold (5) and cylinder head (4).
Tighten screws (1) and (8) 29-37 lb-ft (39-50 Nm) in sequence shown.
5.
6.
Bend tabs of five retaining rings (2) and retaining ring (7) over ten screws (1) and two screws (8).
7.
Apply antiseize compound on threads of four studs (6).
8.
Install four studs (6) on exhaust manifold (5).
9.
Install turbocharger (WP 0325 00).
0317 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version