ENGINE OIL PAN MAINTENANCE - continued - TM-9-2320-386-24-1-20187

TM 9-2320-386-24-1-2

0312 00

ENGINE OIL PAN MAINTENANCE (Contd)

REMOVAL

NOTE

Perform step 1 for in-vehicle maintenance.

Remove screw (16), washer (15), and clamp (13) securing air line (14) to oil pan (8).

NOTE

Perform steps 2 and 3 for vehicles equipped with a winch only.

Remove locknut (4), screw (3), and mounting bracket (1) from crossmember (2). Discard locknut (4).

Position hydraulic lines (5) away from oil pan (8).

NOTE

Only thirty-five screws and washers are removed for in-vehicle

maintenance.

Remove thirty-six screws (10), washers (9), oil pan (8), and gasket (7) from cylinder block (6).

Discard gasket (7).

Remove two plugs (11) and O-rings (12) from oil pan (8). Discard O-rings (12).

CLEANING AND INSPECTION

.WARNING.

Volatile mineral spirits burn easily and fumes can explode. Do not

smoke or allow open flame nearby when using mineral spirits.

Doing so may cause serious injury or death to personnel.

Clean oil pan (8) and all mounting hardware with mineral spirits.

Inspect oil pan (8) for cracks or damage. Repair or replace oil pan (8) if damaged.

INSTALLATION

Install two new O-rings (12) and plugs (11) on oil pan (8).

Apply adhesive on new gasket (7) and position gasket (7) on oil pan (8).

NOTE

Only thirty-five washers and screws are installed for in-vehicle

maintenance.

Install oil pan (8) on cylinder block (6) with thirty-six washers (9) and screws (10).

NOTE

Perform step 4 for vehicles equipped with a winch only.

Install mounting bracket (1) with hydraulic lines (5) on crossmember (2) with screw (3) and new

locknut (4).

NOTE

Perform step 5 for in-vehicle maintenance.

Install air line (14) on oil pan (8) with clamp (13), washer (15), and screw (16).

Fill engine oil to proper level (in-vehicle only) (TM 9-2320-386-10).

Connect battery ground cable (in-vehicle only) (WP 0121 00).

Prime lubrication system (WP 0298 00).

0312 00-2