 |
|||
|
|
|||
|
Page Title:
CAMSHAFT ROLLER FOLLOWERS AND COVERS MAINTENANCE - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-386-24-1-2
0308 00
CAMSHAFT ROLLER FOLLOWERS AND COVERS MAINTENANCE (Contd)
NOTE
Tag camshaft roller followers for installation. There are three
camshaft roller followers for each piston.
6.
Remove four screws (4), two spacers (2), and shaft (3) with six camshaft roller followers (5) from
each side cover (1).
7.
Remove six camshaft roller followers (5) from each shaft (3).
CLEANING AND INSPECTION
1.
Remove adhesive from face of covers (1) and around bolt holes of covers (1).
2.
Clean three side covers (1) with cleaning compound.
.WARNING.
Volatile mineral spirits burn easily and fumes can explode. Do not
smoke or allow open flame nearby when using mineral spirits.
Failure to do so may cause injury to personnel.
3.
Clean camshaft roller followers (5), cover (1), and all other parts with mineral spirits.
4.
Inspect camshaft roller followers (5) for cracks, pitting, wear, or damage. Replace followers if
cracked, pitted, damaged, or if shaft bore measures greater than 0.61787 in. (15.682 mm)
5.
Measure diameter of lifter arm shaft (3). If shaft (3) measures less than 0.61787 in. (15.682 mm), or
is damaged in any way, replace shaft (3).
INSTALLATION
1.
Position six camshaft roller followers (5) on shaft (3).
2.
Install shaft (3) on each side cover (1) with two spacers (2) and four screws (4). Tighten screws (4)
6-12 lb-ft (8-16 Nm).
1
2
3
4
2
5
5
0308 00-4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version