CYLINDER HEAD (IN-VEHICLE) MAINTENANCE - continued

TM 9-2320-386-24-1-2

0302 00

CYLINDER HEAD (IN-VEHICLE) MAINTENANCE (Contd)

33.

Remove screw (8) and washer (9) from fan bracket (10) and mounting bracket (1).

34.

Remove three screws (5) and washers (4) from fan bracket (10) and engine (2).

35.

Alternately loosen two screws (6) until screws (6), fan bracket (10) with fan (7), and front lifting

bracket (3) can be removed from engine (2) as a complete assembly. Remove complete assembly.

36.

Disconnect fuel return line (25) from elbow (26).

Remove screw (15), washer (14), and clamp (16) from ratio control line (13) and fuel return tube (27).

37.

38.

Disconnect ratio control line (13) and two O-rings (17) from connectors (18) and (23) on engine (2)

and governor (24). Discard O-rings (17).

39.

Remove two screws (29) and washers (28) from fuel return tube (27) and engine (2).

Remove screw (12), washer (11), fuel return tube (27), and O-ring (30) from engine (2). Discard O-ring (30).

40.

41.

Remove governor oil tube (20) and two O-rings (19) from elbow (21) on engine (2) and connector (22)

on governor (24). Discard O-rings (19).

42.

Disconnect wiring harness connector 569B (38) from coolant temperature switch plug (31).

43.

Disconnect temperature sender lead 33 (32) from temperature sender (33).

44.

Remove screw (37), clamp (36) with wiring harness (35), ground (GND) lead (39), and lockwasher (34)

from mounting bracket (1). Discard lockwasher (34).

0302 00-10