 |
|||
|
|
|||
|
Page Title:
PREPARING REPLACEMENT ENGINE FOR INSTALLATION IN VEHICLE - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-386-24-1-2
0297 00
PREPARING REPLACEMENT ENGINE FOR INSTALLATION IN VEHICLE (Contd)
INSTALLATION
NOTE
Before tightening jamnut on sensor, adjust sensor 1-1/4 turns out from
flywheel. Nut functions as a jamnut to hold the sensor in position.
1.
Install magnetic speed sensor (7) on flywheel housing (8) and tighten jamnut (6) finger-tight.
2.
Apply sealant to male threads on elbow (26) and adapter (27).
3.
Install elbow (26) on air compressor (23).
4.
Install bracket (3) on front housing (25) with washer (2) and screw (1).
5.
Connect spring (4) to bracket (3) and throttle bracket (24).
6.
Install new O-ring (29), connector (28), and adapter (27) on water pump (36).
NOTE
Perform step 7 if removed engine is equipped with hydraulic
pump.
7.
Install new gasket (19) and pump (18) on air compressor (23) with two new lockwashers (15) and
screws (14)
2
3
4
1
6
5
26
7
25
24
23
22
21
20
8
14
15
19
10
18
11
9
0297 00-4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version