 |
|||
|
|
|||
|
Page Title:
PREPARING REPLACEMENT ENGINE FOR INSTALLATION IN VEHICLE - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-386-24-1-2
0297 00
PREPARING REPLACEMENT ENGINE FOR INSTALLATION IN VEHICLE (Contd)
REMOVAL
CAUTION
Cap or plug all openings immediately after disconnecting lines
and hoses to prevent contamination. Remove caps or plugs prior to
installation. Failure to do so may result in damage to equipment.
1.
Remove four screws (18), lockwashers (19), and right support (17) from flywheel housing (20).
Discard lockwashers (19).
2.
Remove four screws (29), lockwashers (28), and left support (27) from flywheel housing (20).
Discard lockwashers (28).
3.
Remove two screws (7), lockwashers (6), and top radiator bracket (5) from fan housing (8) on
engine (1). Discard lockwashers (6).
4.
Remove two screws (35), lockwashers (34), and lower radiator bracket (36) from engine (1). Discard
lockwashers (34).
5.
Remove two locknuts (13), screws (9), washers (10), and bracket (12) from engine (1). Discard
locknuts (13).
6.
Remove two screws (16), washers (15), and bracket (14) from engine (1).
7.
Remove adapter (2), connector (3), and O-ring (4) from water pump (11). Discard O-ring (4).
8.
Remove screw (21), washer (22), bracket (23), and spring (24) from front housing (39) and throttle
bracket (38).
9.
Remove elbow (40) from air compressor (37).
10.
Loosen jamnut (25) and remove magnetic speed sensor (26) from flywheel housing (20).
NOTE
Perform step 11 if vehicle is equipped with front winch.
11.
Remove two screws (30), lockwashers (31), pump (32), and gasket (33) from air compressor (37).
Discard lockwashers (31) and gasket (33).
0297 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version