POWER PLANT REPLACEMENT - continued - TM-9-2320-386-24-1-20059

TM 9-2320-386-24-1-2

0295 00

POWER PLANT REPLACEMENT (Contd)

78.

Remove nut (5), ground strap (4), and lockwasher (3) from stud (1) on firewall (2). Discard

lockwasher (3).

79.

Slide collar (10) back and remove accelerator cable (12) from ball joint (8).

80.

Remove cotter pin (6) and control cable pivot (9) from bracket (7). Discard cotter pin (6).

81.

Remove two screws (14), washers (13), and bracket (15) with throttle control cable (11) and

accelerator cable (12) from rear fuel pump housing (16).

82.

Remove nut (30), lockwasher (31), STE/ICE-R harness lead 770-R (32), and engine harness

lead 54-A (35) from fuel shutoff solenoid (17). Discard lockwasher (31).

83.

Remove nut (20), lockwasher (19), and engine harness ground (GND) lead (18) from fuel shutoff

solenoid (17). Discard lockwasher (19).

84.

Disconnect STE/ICE-R connector lead (34) from fuel pressure sender connector leads (33).

85.

Disconnect oil pressure sender lead 36 (21) from engine oil pressure transducer (22).

86.

Remove nut (29), washer (28), STE/ICE-R harness (25), engine wiring harness (26), clamp (27), and

ground (GND) lead (24) from stud (23).

WARNING

Diesel fuel is flammable. Do not perform fuel system procedures near

open flames. Failure to comply may result in injury to personnel.

NOTE

Have drainage container ready to catch fuel.

87.

Loosen nut (47) and remove fuel inlet hose (45) from elbow (44) on fuel pump (43).

88.

Loosen nut (36) and remove fuel outlet hose (46) from elbow (37) on fuel pump (43).

89.

Remove locknut (41), washer (40), screw (38), two clamps (39), fuel inlet hose (45), and fuel outlet

hose (46) from bracket (42). Discard locknut (41).

0295 00-18