 |
|||
|
|
|||
|
Page Title:
CTIS MANIFOLD AND EXHAUST REPLACEMENT - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-386-24-1-1
0282 00
CTIS MANIFOLD AND EXHAUST REPLACEMENT (Contd)
REMOVAL
.WARNING.
Do not disconnect air lines and fittings before draining air
reservoirs. Small parts under pressure may shoot out with high
velocity, causing injury to personnel.
Eyeshields must be worn when releasing compressed air. Failure
to do so may result in injury to personnel.
1.
Remove crimp nut (11), sleeve (10), elbow (9), and bushing (12) from manifold (2).
2.
Remove three tubes (14), elbows (13), and bushings (15) from manifold (2).
3.
Remove plug (1) from manifold (2).
4.
Remove priority pressure switch tube (5), elbow (4), and elbow (3) from manifold (2).
5.
Remove air intake tube (6), elbow (7), and elbow (8) from manifold (2).
6.
Remove tiedown straps (22) as necessary. Discard tiedown straps (22).
7.
Disconnect CTIS control harness (18) from manifold (2).
8.
Remove screw (19), lockwasher (20), and three ground (GND) leads (21) from manifold (2). Discard
lockwasher (20).
9.
Disconnect lead 27 (16) from plug (17).
10.
Remove four locknuts (24), washers (25), screws (26), washers (25), and manifold (2) from mounting
bracket (23). Discard locknuts (24).
CAUTION
Place a jack stand under fuel tank to prevent equipment damage.
NOTE
Leave four screws in frame rail to support weight of fuel tank.
11.
Remove four locknuts (27), washers (28), and manifold mounting bracket (23) from screws (29) and
frame rail (30). Discard locknuts (27).
0282 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version