 |
|||
|
|
|||
|
Page Title:
AIR DRYER AND AIR DRYER HEATER MAINTENANCE - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-386-24-1-1
0281 00
AIR DRYER AND AIR DRYER HEATER MAINTENANCE (Contd)
AIR DRYER HEATER REMOVAL
1.
Remove nut (10), lockwasher (9), and clamp (8) with air dryer heater connector (11) from clamp (2).
Discard lockwasher (9).
2.
Disconnect air dryer heater connector (11) from wiring harness connector 27 (12) and remove
clamp (8) from wire (7).
3.
Remove three screws (4), retainer plate (3), and purge shield (5) from air dryer (1).
4.
Remove air dryer heater (6) from air dryer (1).
AIR DRYER HEATER INSTALLATION
1.
Apply small amount of conductive lubricant supplied in kit to temperature sensor (13) on air dryer
heater (6).
2.
Position air dryer heater (6) on air dryer (1).
3.
Install purge shield (5) and retainer plate (3) on air dryer (1) with three screws (4). Tighten
screws (4) 30-50 lb-in. (3-6 Nm).
4.
Install clamp (8) on wire (7) and connect air dryer heater connector (11) to wiring harness
connector 27 (12).
5.
Install clamp (8) with air dryer heater connector (11) on clamp (2) with new lockwasher (9) and
nut (10).
6.
Connect battery cables (WP 0121 00).
7.
Start engine (TM 9-2320-386-10) and allow air pressure to build up to normal operating pressure.
Check heater operation if temperature is 40F (4C) or below.
0281 00-8
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version