 |
|||
|
|
|||
|
Page Title:
BRUSHGUARD REPLACEMENT - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-386-24-1-1
0230 00
BRUSHGUARD REPLACEMENT (Contd)
INSTALLATION
CAUTION
When installing auxiliary oil cooler, do not compress rubber
mounts more than the thickness of the oil cooler.
1.
Install two bumpers (28) on brushguard (1) with eight new rivets (29).
2.
Install auxiliary oil cooler (23) on brushguard (1) with four rubber mounts (30), washers (31), and
screws (32).
3.
Position brushguard (1) on vehicle.
4.
Install two baffles (17) on brushguard (1) with four screws (16) and new locknuts (15).
5.
Install brushguard (1) on studs (21) with two washers (20), new lockwashers (19), and nuts (18).
6.
Install oil line (22) on elbow (27), and oil filter line (25) on elbow (24).
7.
Install two strut rods (3) on brushguard (1) with retaining pins (2) and new cotter pins (14).
8.
Install two lower side panels (13) on fenders (6) with four screws (4), washers (8), and new locknuts (9).
9.
Install two lower side panels (13) on brushguard (1) with four washers (10), new lockwashers (11),
and screws (12).
10.
Install two upper side panels (5) on hinges (7) and slide panels (5) rearward into position. Close and
lock side panels (5).
11.
Install quick-start mounting brackets (for vehicles built after serial No. 504923 only) (WP 0061 00).
12.
Ensure brushguard is properly aligned with hood (WP 0229 00).
0230 00-4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version