 |
|||
|
|
|||
|
Page Title:
FRONT WINCH CABLE MAINTENANCE - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-386-24-1-1
0224 00
FRONT WINCH CABLE MAINTENANCE (Contd)
REMOVAL
1. Place transmission gear shift lever (10) in NEUTRAL.
2. Pull out and rotate drum lock knob (8) clockwise a quarter turn, and release into shallow slot on
nut (9).
3. Move winch clutch control lever (1) to OUT position (toward center of vehicle).
NOTE
If cable chain hook will not pass through lifting shackle,
disassemble lifting shackle to remove cable chain hook.
4. Remove winch cable chain hook (5) from right lifting shackle (6), pass hook (5) through left lifting
shackle (2), and pull winch cable (3) from drum (13).
5. Loosen setscrew (14) and remove front winch cable (3) from drum (13).
6. Remove nut (15), screw (17), and chain (16) from clevis (18).
7. Remove cap (20), winch cable (3), and plug (19) from clevis (18).
8. Remove plug (19) and cap (20) from winch cable (3).
CLEANING AND INSPECTION
.WARNING.
Eye protection is required when using a wire brush for cleaning.
Failure to do this may result in injury to personnel.
1.
Soak winch cable (3) in lubricating oil (TM 9-2320-386-10). Clean winch cable (3) with wire brush.
2.
Inspect cable (3) and parts for breaks and wear. Replace cable (3) and/or parts if broken or worn.
3.
Lubricate winch drum (14) and winch cable (3) with lubricating oil (WP 0023 00).
INSTALLATION
1. Position cap (20) on winch cable (3) and install plug (19) on winch cable (3).
.WARNING.
Cable end must be properly assembled on clevis. Failure to do this
may cause cable to separate resulting in injury to personnel.
NOTE
When properly assembled, cable end must be visible through
inspection hole in clevis.
2.
Install plug (19), winch cable (3), and cap (20) on clevis (18).
3.
Install chain (16) on clevis (18) with screw (17) and nut (15).
4.
Connect winch cable (3) to drum (13) and tighten setscrew (14).
5.
Move winch clutch control lever (1) to IN position (toward passenger side of vehicle).
6.
Start engine (TM 9-2320-386-10).
7.
Place winch control valve lever (12) in ENGAGE position.
8.
Hold winch control switch (11) in PAY IN position.
NOTE
Ensure first layer of winch cable goes onto drum in order and that
each additional layer starts back across the drum. If necessary,
use a wooden block to assist in cable alignment.
9.
When winch cable (3) is fully wound on drum, release winch control switch (11) and place winch
control valve lever (12) in DISENGAGE position.
NOTE
If cable chain hook will not pass through lifting shackle,
disassemble lifting shackle to install cable chain hook.
0224 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version