 |
|||
|
|
|||
|
Page Title:
FRONT WINCH CONTROLS REPLACEMENT - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-386-24-1-1
0223 00
FRONT WINCH CONTROLS REPLACEMENT (Contd)
REMOVAL
1.
Remove six screws (1) and cover (2) from tower (6).
WARNING
Do not disconnect tubes before draining air reservoirs. Small
parts under pressure may shoot out with high velocity, causing
injury to personnel.
Eyeshields must be worn when releasing compressed air. Failure
to do this may result in injury to personnel.
CAUTION
Plug all openings immediately after disconnecting tubes and
fittings to prevent dirt and dust from entering compressed air
system. Contamination of the compressed air system may result
in damage to equipment. Remove plugs before installation.
NOTE
Tag hoses for installation.
2.
Remove
tube (12) from fitting (23).
3.
Remove
tube (14) from tee (15).
4.
Remove
fitting (23) from control (9).
5.
Remove
tee (15) from control (9).
6.
Remove
four locknuts (22), screws (10), and control (9) from tower (6). Discard locknuts (22).
7.
Remove
nut (8), lockwasher (7), and switch (4) from tower (6). Discard lockwasher (7).
8.
Remove
nut (17), sleeve (18), and tube (13) from elbow (19).
9.
Remove
nut (21), sleeve (20), and tube (11) from elbow (5).
10.
Remove
elbows (19) and (5) from switch (4).
11.
Remove
tube (16) from tee (15) and swivel elbow (3).
12.
Remove
swivel elbow (3) from switch (4).
INSTALLATION
1. Apply sealant to male threads of swivel elbow (3), elbows (5) and (19), fitting (23), and tee (15).
2. Install swivel elbow (3) on switch (4).
3. Install tube (16) on tee (15) and swivel elbow (3).
4. Install elbows (19) and (5) on switch (4).
5. Install sleeve (18), nut (17), and tube (13) on elbow (19).
6. Install sleeve (20), nut (21), and tube (11) on elbow (5).
7. Install switch (4) on tower (6) with new lockwasher (7) and nut (8).
8. Install control (9) on tower (6) with four screws (10) and new locknuts (22).
9. Install tee (15) on control (9).
10. Install fitting (23) on control (9).
11. Install tube (14) on tee (15).
12. Install tube (12) on fitting (23).
13. Install cover (2) on tower (6) with six screws (1).
14. Start engine (TM 9-2320-386-10) and check controls for proper operation.
0223 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version