 |
|||
|
|
|||
|
Page Title:
FRONT WINCH HYDRAULIC OIL RESERVOIR MAINTENANCE - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-386-24-1-1
0219 00
FRONT WINCH HYDRAULIC OIL RESERVOIR MAINTENANCE (Contd)
CLEANING AND INSPECTION
WARNING
Volatile mineral spirits burn easily and fumes can explode. Do not
smoke or allow flames nearby when using volatile mineral spirits.
Failure to do so may cause serious injury to personnel.
1.
Clean all metallic parts with mineral spirits and dry with a lint-free rag.
2.
Inspect all metallic parts for wear, scratches, grooves, and burrs. Remove scratches and burrs with
crocus cloth. Replace any parts that show visible signs of being either worn or grooved.
3.
Inspect webbing (24) and (28). Remove and replace any webbing (24) and (28) with visible signs of
wear or damage.
INSTALLATION
NOTE
If webbing was removed during cleaning and inspection, perform
steps 1 through 4.
1.
Cut new webbing (28) approximately 15.25 in. (38.7 cm) for retaining straps (4) and (27).
2.
Apply adhesive to two retaining straps (4) and (27). Position new webbing (28) .25 in. (0.6 cm) from
end and centered on retaining straps (4) and (27).
3.
Cut four pieces of new webbing (24) approximately 28-30 in. (71-76 cm) for support bracket (21).
4.
Apply adhesive to support bracket (21). Position new webbing (24) 4 in. (10 cm) from end and
centered on support bracket (21).
5.
Apply silicone adhesive to mating surface of screen (15) and lockplate (14) and install screen (15)
and lockplate (14) on reservoir (17) with six screws (13).
6.
Install cap (8) on lockplate (14).
7.
Apply sealant to male threads of sight glass (20) and filter (16).
8.
Install filter (16) on reservoir (17).
9.
Install new gasket (19) and drainplug (18) on reservoir (17).
10.
Install sight glass (20) on reservoir (17).
11.
Install support bracket (21) on rail (12) and rail extension (6) with three screws (26) and new
locknuts (7).
12.
Install wiring harness (9) on rail (12) with clamp (10), screw (25), and new locknut (11).
13.
Install two retaining straps (4) on support bracket (21) with two screws (5) and new locknuts (3).
14.
Install two retaining straps (27) on support bracket (21) with two screws (22) and new
locknuts (23).
15.
Position reservoir (17) on support bracket (21).
16.
Connect two retaining straps (4) and (27) with screws (1) and new locknuts (2).
17.
Install new O-ring (31), elbow (30), and hose (29) on reservoir (17).
18.
Install new O-ring (34), elbow (33), and tube (32) on reservoir (17).
19.
Install front winch hydraulic control valve (WP 0218 00).
20.
Install front winch AOAP valve (WP 0216 00).
21.
Install front winch hydraulic vent valve (WP 0217 00).
22.
Fill hydraulic oil reservoir to proper level (WP 0213 00).
0219 00-4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version