FRONT WINCH HYDRAULIC CONTROL VALVE MAINTENANCE - continued

TM 9-2320-386-24-1-1

0218 00

FRONT WINCH HYDRAULIC CONTROL VALVE MAINTENANCE (Contd)

REMOVAL

CAUTION

Plug all openings immediately after disconnecting hoses and

fittings to prevent dirt and dust from entering hydraulic system.

Contamination of the hydraulic system may result in damage to

equipment. Remove plugs before installation.

Remove three screws (2), washers (3), and angle bracket (1) from reservoir (4).

NOTE

Tag all hoses for installation.

Remove snapring (18) and tube (17) from elbow (19).

Remove snapring (13) and tube (14) from elbow (15).

Remove elbows (15) and (19) from control valve (5).

Remove hose connector (8) from elbow (7).

Remove hose connector (9) from elbow (10).

Remove elbows (7) and (10) and O-rings (6) and (16) from control valve (5). Discard O-rings (6)

and (16).

8. Remove hose connector (20) from elbow (21).

9. Remove elbow (21) and O-ring (22) from control valve (5). Discard O-ring (22).

10. Remove two screws (12), screw (11), control valve (5), and plate (23) from reservoir (4).

INSPECTION

Check control valve (5) body casting for cracks, leaks, and condition of internal threads. Replace control

valve (5) if damaged.

INSTALLATION

Apply sealant to male threads of elbows (7), (10), (15), (19), and (21).

Install control valve (5) and plate (23) on reservoir (4) with two screws (12) and screw (11).

Install new O-ring (22) and elbow (21) on control valve (5).

Install hose connector (20) on elbow (21).

Install new O-rings (6) and (16) and elbows (7) and (10) on control valve (5).

Install hose connector (9) on elbow (10).

Install hose connector (8) on elbow (7).

Install elbows (15) and (19) on control valve (5).

Install tube (14) on elbow (15) with snapring (13).

10.

Install tube (17) on elbow (19) with snapring (18).

11.

Install angle bracket (1) on reservoir (4) with three washers (3) and screws (2).

12.

Install front winch hydraulic oil filter base (WP 0215 00).

0218 00-2