 |
|||
|
|
|||
|
Page Title:
FRONT WINCH HYDRAULIC OIL FILTER BASE REPLACEMENT - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-386-24-1-1
0215 00
FRONT WINCH HYDRAULIC OIL FILTER BASE REPLACEMENT (Contd)
REMOVAL
1.
Loosen two hose connectors (2) and remove hose (5), fitting (3), and O-rings (1) and (4) from control
valve (16) and vent valve (5). Discard O-rings (1) and (4).
2.
Remove oil filter (12) from oil filter base (11). Discard oil filter (12).
3.
Remove reducer (9), fitting (8), and O-ring (7) from vent valve (6) and oil filter base (11). Discard
O-ring (7).
4.
Remove oil filter base (11) with elbow connector (13) from fitting (14).
5.
Remove fitting (14) and O-ring (15) from reservoir (17). Discard O-ring (15).
6.
Remove elbow connector (13) from oil filter base (11).
7.
Remove gauge (10) from oil filter base (11).
INSTALLATION
1.
Apply sealant to male threads of hose connectors (2), fittings (3), (8), and (14), reducer (9), elbow
connector (13), and gauge (10).
2.
Install gauge (10) on oil filter base (11).
3.
Install reducer (9) and elbow connector (13) on oil filter base (11).
4.
Install new O-ring (15) and fitting (14) on reservoir (17).
5.
Install new O-ring (7) and fitting (8) on vent valve (6).
6.
Install oil filter base (11) with elbow connector (13) and reducer (9) on fitting (14) and fitting (8).
7.
Apply lubricating oil to seal of new oil filter (12).
8.
Install oil filter (12) on oil filter base (11). Tighten oil filter (12) until it contacts oil filter base (11),
then tighten an additional 7/8- to 1-full turn.
9.
Install O-rings (1) and (4), fitting (3), and hose (5) on vent valve (6) and control valve (16) and
tighten hose connectors (2).
10.
Fill hydraulic oil reservoir to proper level (WP 0213 00).
0215 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version