 |
|||
|
|
|||
|
Page Title:
SEATBELT POSTS AND BRACKETS REPLACEMENT - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-386-24-1-1
0210 00
SEATBELT POSTS AND BRACKETS REPLACEMENT (Contd)
INSTALLATION
NOTE
Left and right seatbelt post installation is the same. Steps 1
through 5 cover the left side.
1.
Install left gusset bracket (2) on left reinforcement plate (7) and rear cab wall (1) with two
washers (3) and screws (4).
2.
Install left seatbelt post (8) on rear cab wall (1) with eight washers (10) and screws (11).
3.
Install two washers (6), screws (9), washers (6), and new locknuts (5) in upper holes of left seatbelt
post (8) and left gusset bracket (2).
4.
Install left reinforcement bracket (19) on rear cab wall (1) with four washers (15), screws (14), and
new locknuts (18).
NOTE
Ensure straight portion of tether is installed on left reinforcement
bracket with bent portion facing toward driver's door.
5.
Install tether (20) and sleeve (16) on left reinforcement bracket (19) with washer (13), screw (12),
washer (13), and new locknut (17). Tighten screw (12) 20-25 lb-ft (27-34 Nm).
6.
Install support bracket (52) on rear cab wall (1) with two screws (44) and new locknuts (51).
7.
Install resilient mount (43) on reinforcement bracket (52) with screw (42), washer (22), and new
plain-assembled nut (21).
8.
Install reinforcement plate (40) on rear cab wall (1) with two screws (23) and new locknuts (41).
9.
Install center post (26) on rear cab wall (1) with six washers (28) and screws (29).
10.
Install two washers (25), screws (27), washers (25), and new locknuts (24) in upper holes of center
post (26) and rear cab wall (1).
11.
Install two upper reinforcement plates (49), lower reinforcement plates (47), and left and right
center reinforcement brackets (38) and (39) on rear cab wall (1) with sixteen washers (30),
screws (31), washers (30), and new locknuts (48).
NOTE
Ensure straight portion of tether is installed on center
reinforcement bracket with bent portion facing outward.
12.
Install support bracket (36), sleeve (35), and tether (34) on left center reinforcement bracket (38)
with washer (33), screw (32), washer (33), and locknut (37). Tighten screw (32) 20-25 lb-ft
(27-34 Nm).
13.
Install two support brackets (36) and sleeve (35) on right center reinforcement bracket (39) with
washer (30), screw (32), washer (33) and new locknut (37).
14.
Install NBC bracket (45) on rear cab wall (1) with two screws (46) and new locknuts (50).
15.
Install driver's and companion seatbelts (WP 0211 00).
0210 00-4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version