 |
|||
|
|
|||
|
Page Title:
DRIVER'S SEAT REPAIR - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-386-24-1-1
0209 00
DRIVER'S SEAT REPAIR (Contd)
DISASSEMBLY
1.
Remove four nuts (11), lockwashers (10), washers (9), and seat assembly (5) from seat support
plate (8). Discard lockwashers (10).
2.
Remove four screws (1), washers (2), and seat backrest (6) from right and left side support
brackets (4).
3.
Remove four screws (1), washers (2), seatbelt bracket (3), and right and left side support
brackets (4) from seat cushion (31).
4.
If replacement is necessary, remove eighteen upholstery clips (30) and seat cushion upholstery from
seat cushion (31). Discard upholstery clips (30).
5.
If replacement is necessary, remove ten retaining rings (7) and seat backrest upholstery from seat
backrest (6). Discard retaining rings (7).
6.
Remove four locknuts (29), screws (26), washers (27), seat support plate (8), and four spacers (28)
from slide adjuster assemblies (15). Discard locknuts (29).
7.
Remove two locknuts (43), four screws (32), contact washers (51), slide adjuster assemblies (15),
and four spacers (50) from seat support mechanism assembly (12). Discard locknuts (43).
8.
Remove two screws (14) and seatbelt bar (13) from seat support mechanism assembly (12).
9.
Remove pin (25), weight adjuster knob (24), and cover (23) from weight adjuster shaft (22).
10.
Remove two push pins (34), four U-clips (33), push pins (49), and boot (21) from seat support
mechanism assembly (12).
Remove four screws (17), lockwashers (18), washers (19), seat riser (16), and four spacers (20) from
11.
seat support mechanism assembly (12). Discard lockwashers (18).
12.
Remove two nuts (42), lockwashers (41), and stop bumpers (40) from seat support mechanism
assembly (12). Discard lockwashers (41).
NOTE
Shock absorber is supplied as a kit. Perform steps 13 through 16
only if shock absorber is damaged.
13.
Remove locknut (35) and screw (38) from bottom support bracket (39) and shock absorber (36).
Discard locknut (35).
14.
Remove locknut (48), pry spring (45) back, and slide screw (46) out from upper support bracket (44)
and shock absorber (36). Discard locknut (48).
15.
Remove shock absorber (36) from seat support mechanism assembly (12) and slide inserts (37)
and (47) out from ends of shock absorber (36). Discard inserts (37) and (47) and shock absorber (36).
0209 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version