FRONT UPPER AND LOWER SHACKLES AND BRACKETS (WO/WINCH) REPLACEMENT - continued

TM 9-2320-386-24-1-1

0188 00

FRONT UPPER AND LOWER SHACKLES AND BRACKETS (WO/WINCH) REPLACEMENT (Contd)

NOTE

Left and right upper and lower shackles and brackets are replaced basically

the same way. This task covers the right upper and lower shackles and

brackets.

REMOVAL

1. Remove retaining pin (9) from pin (8).

2. Remove pin (8) and upper shackle (7) from upper bracket (11).

3. Remove locknut (19), screw (15), and lower shackle (18) from lower bracket (14). Discard

locknut (19).

4. Remove two locknuts (10), screws (17), four washers (16), locknut (20), screw (6), lower bracket (14),

spacer (21), and three spacers (1) from upper bracket (11) and bumper (3). Discard locknuts (10)

and (20).

5. Remove locknut (2), screw (5), bracket (4), and upper bracket (11) from bumper (3). Discard

locknut (2).

INSTALLATION

1. Install upper bracket (11) and bracket (4) on bumper (3) with screw (5) and new locknut (2).

2. Position spacer (21) and lower bracket (14) on lower bumper support bracket (13).

3. Install three spacers (1) and upper bracket (11) on upper bumper support bracket (12) and

bumper (3) with screw (6), two screws (17), four washers (16), two new locknuts (10), and new

locknut (20).

4. Install lower shackle (18) on lower bracket (14) with screw (15) and new locknut (19).

5. Install upper shackle (7) on upper bracket (11) with pin (8).

6. Install retaining pin (9) in pin (8). Latch retaining pin (9).

7. Install brushguard (WP 0230 00).

8. Install blackout drive lamp and housing (WP 0105 00).

0188 00-2