 |
|||
|
|
|||
|
Page Title:
STEERING ASSIST HOSE REPLACEMENT - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-386-24-1-1
0186 00
STEERING ASSIST HOSE REPLACEMENT (Contd)
REMOVAL
.WARNING.
Do not disconnect air lines before draining air reservoirs. Small
parts under pressure may shoot out with high velocity, causing
injury to personnel.
Eyeshields must be worn when releasing compressed air. Failure
to do this may result in injury to personnel.
CAUTION
When disconnecting air lines and hoses, plug all openings to
prevent dirt from entering and causing damage to internal parts.
1.
Remove tiedown strap (16) from hoses (13) and (17). Discard tiedown strap (16).
2.
Remove connector (20) from fitting (19).
3.
Remove connector (22) from fitting (21).
4.
Remove connector (15) from elbow (14).
5.
Remove connector (11) from fitting (12).
6.
Remove locknut (18), screw (1), and hoses (13) and (17) from clamp (3) and mounting bracket (2).
Discard locknut (18).
7.
Remove hoses (13) and (17) and grommets (4) and (5) from fender (6).
8.
Remove locknut (7), screw (10), and hose (13) from clamp (8) and mounting bracket (9).
INSTALLATION
NOTE
Remove all plugs prior to installation of air lines and hoses.
1.
Apply sealant to male threads of elbow (14) and fittings (12), (19), and (21).
2.
Install hoses (13) and (17) and grommets (4) and (5) in fender (6).
3.
Install connector (11) on fitting (12).
4.
Install connector (15) on elbow (14).
5.
Install connector (20) on fitting (19).
6.
Install connector (22) on fitting (21).
7.
Install hoses (13) and (17) on mounting bracket (2) with clamp (3), screw (1), and new locknut (18).
8.
Install hose (13) on mounting bracket (9) with clamp (8), screw (10), and new locknut (7).
9.
Install new tiedown strap (16) on hoses (13) and (17).
10.
Start engine (TM 9-2320-386-10) and allow air pressure to build up to normal operating level.
Check for air leaks and road test vehicle.
0186 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version