 |
|||
|
|
|||
|
Page Title:
STEERING ASSIST REGULATOR REPLACEMENT - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-386-24-1-1
0184 00
STEERING ASSIST REGULATOR REPLACEMENT (Contd)
REMOVAL
.WARNING.
Do not disconnect air lines before draining air reservoirs. Small
parts under pressure may shoot out with high velocity, causing
injury to personnel.
Eyeshields must be worn when releasing compressed air. Failure
to do this may result in injury to personnel.
CAUTION
When disconnecting air lines and hoses, plug all openings to
prevent dirt from entering and causing damage to internal parts.
1.
Remove tube (9) from fitting (10).
2.
Remove fitting (10) from elbow (11).
3.
Remove elbow (11) from hollow stud (7).
4.
Remove tube (1) from adapter (2).
5.
Remove nut (12) and lockwasher (13) from hollow stud (7) and regulator (3) from rail (8). Discard
lockwasher (13).
6.
Remove hollow stud (7) from fitting (6).
7.
Remove fitting (6) from elbow (5).
8.
Remove elbow (5) from fitting (4).
9.
Remove fittings (2) and (4) from regulator (3).
INSTALLATION
NOTE
Remove all plugs prior to installation of air lines.
1.
Apply sealant to male threads of fittings (2), (4), (6), and (10), elbows (5) and (11), and hollow
stud (7).
2.
Install fittings (2) and (4) on regulator (3).
3.
Install elbow (5) on fitting (4).
4.
Install fitting (6) on elbow (5).
5.
Install hollow stud (7) on fitting (6).
6.
Position regulator (3) on rail (8) and install hollow stud (7) on rail (8) with new lockwasher (13) and
nut (12).
7.
Install tube (1) on adapter (2).
8.
Install elbow (11) on hollow stud (7).
9.
Install fitting (10) on elbow (11).
10.
Install tube (9) on fitting (10).
11.
Start engine (TM 9-2320-386-10) and allow air pressure to build up to normal operating pressure.
Check for air leaks and road test vehicle.
0184 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version