 |
|||
|
|
|||
|
Page Title:
STEERING ASSIST CYLINDER MAINTENANCE - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-386-24-1-1
0183 00
STEERING ASSIST CYLINDER MAINTENANCE (Contd)
REMOVAL
.WARNING.
Do not disconnect air lines before draining air reservoirs. Small
parts under pressure may shoot out with high velocity, causing
injury to personnel.
Eyeshields must be worn when releasing compressed air. Failure
to do this may result in injury to personnel.
CAUTION
When disconnecting air lines and hoses, plug all openings to
prevent dirt from entering and causing damage to internal parts.
NOTE
Tag all air lines and hoses for installation.
1.
Raise vehicle (TM 9-2320-386-10), place jack stands under front axle, and lower vehicle onto jack
stands.
2.
Remove tiedown straps (1) as required. Discard tiedown straps (1).
3.
Remove air hose (20) from elbow (19).
4.
Remove air hose (2) from adapter (3).
5.
Remove elbow (19) and adapter (3) from steering assist cylinder (12).
6.
Remove six jamnuts (13) from screws (17).
NOTE
Support steering assist cylinder during removal.
7.
Remove six nuts (14), tie rod top bracket (15), six screws (17), and tie rod bottom bracket (16) from
tie rod (18).
NOTE
Assistant will help with step 8.
8.
Remove locknut (10), washer (9), screw (4), washer (5), support bracket (6) with air hose (2), and
steering assist cylinder (12) from axle bracket (8). Discard locknut (10).
9.
Remove two spacers (7) and pull steering assist cylinder (12) with rubber bearing shields (11) from
axle bracket (8).
0183 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version