 |
|||
|
|
|||
|
Page Title:
DRAG LINK MAINTENANCE - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-386-24-1-1
0181 00
DRAG LINK MAINTENANCE (Contd)
5.
Remove cotter pins (1) and (9) from drag link (17). Discard cotter pins (1) and (9).
6.
Remove connector (4) from fitting (3).
7.
Remove connector (7) from fitting (8).
8.
Remove connector (18) from elbow (16).
9.
Remove tiedown strap (2) from splitter (13). Discard tiedown strap (2).
10.
Remove connector (12) from fitting (11).
11.
Remove connector (14) from fitting (15).
12.
Turn adjusting plugs (10) and (19) until almost out of drag link (17).
13.
Turn steering wheel as needed to remove drag link (17) from steering arm (6) and pitman arm (5).
14.
Remove elbow (16) and fittings (3), (8), (11) and (15) from drag link (17).
INSTALLATION
NOTE
Remove all plugs prior to installation of air lines.
The steering arm end of the drag link is the side with the
adjustable end.
When installed, the drag link must have exhaust ports in the
down position.
1.
Apply sealant to male threads of elbow (16) and fittings (3), (8), (11) and (15).
2.
Install elbow (16) and fittings (3), (8), (11), and (15) on drag link (17).
3.
Install drag link (17) on pitman arm (5) and steering arm (6).
4.
Straighten steering wheel to center position.
5.
Lubricate drag link (17) with GAA grease.
6.
Tighten adjusting plugs (10) and (19) until seated (metal to metal), then back off one-half turn, and
install new cotter pins (1) and (9).
7.
Install connector (4) on fitting (3).
8.
Install connector (7) on fitting (8).
9.
Install connector (18) on elbow (16).
10.
Install new tiedown strap (2) on splitter (13).
11.
Install connector (12) on fitting (11).
12.
Install connector (14) on fitting (15).
0181 00-4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version