 |
|||
|
|
|||
|
Page Title:
PITMAN ARM MAINTENANCE - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-386-24-1-1
0180 00
PITMAN ARM MAINTENANCE (Contd)
INSTALLATION
1.
Align marks on pitman arm (3) and shaft (4) and slide pitman arm (3) on shaft (4) until threaded
end of shaft (4) is exposed.
2.
Install new lockwasher (2) and nut (1) on shaft (4). Tighten nut (1) 180-200 lb-ft (244-271 Nm).
3.
Install drag link (6) on pitman arm ball (8).
4.
Lubricate drag link (6) with (GAA) grease.
5.
Tighten adjusting plug (7) until seated (metal-to-metal), then back off adjusting plug (7) (minimum
one-half turn), and install new cotter pin (5).
Install stone shield (10) on studs (12) with two nuts (9). Tighten nuts (9) 60-80 lb-ft (81-108 Nm).
6.
7.
Install stone shield (10) on flange (11) with two new lockwashers (13) and screws (14). Tighten
screws (14) 81-104 lb-ft (110-141 Nm).
8.
Repeat steps 6 and 7 to install two stone shields.
4
3
5
4
3
ALIGNMENT
MARKS
2
1
8
7
6
0180 00-4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version