FRONT AXLE HYDRAULIC BRAKE LINE REPLACEMENT - continued

TM 9-2320-386-24-1-1

0161 00

FRONT AXLE HYDRAULIC BRAKE LINE REPLACEMENT (Contd)

REMOVAL

CAUTION

When disconnecting hydraulic brake lines and hoses, cap and plug

all openings to prevent dirt and dust from entering. Contamination

of the brake system may result in damage to equipment. Remove

caps and plugs prior to installation.

NOTE

Right and left side flexible hydraulic brake lines are removed the same.

This procedure shows the left side flexible hydraulic brake line.

Have drainage container ready to catch brake fluid.

Tag all brake lines for installation.

Disconnect spring (7) from spring plate (5).

Remove locknut (15), screw (6), spring (7), and clamp (8) from flexible hydraulic brake line (16).

Discard locknut (15).

Remove hydraulic brake line (13) from flexible hydraulic brake line (16).

Remove nut (12), lockwasher (14), and flexible hydraulic brake line (16) from bracket (10). Discard

lockwasher (14).

Remove screw (4), washer (2), connector (3) with flexible hydraulic brake line (16), and washer (2)

from hydraulic wheel cylinder (1). Discard washers (2).

Remove flexible hydraulic brake line (16) from connector (3).

Remove two assembled-washer bolts (9) and bracket (10) from axle housing (11). Discard

assembled-washer bolts (9).

NOTE

Repeat steps 1 through 7 to remove right side flexible hydraulic

brake line.

Remove nut (31), washer (30), clamp (29), and hydraulic brake line (13) from differential carrier (28).

Remove hydraulic brake line (13) from tee (26).

10.

Remove hydraulic brake line (25) from tee (26).

11.

Remove flexible hydraulic brake line (17) from tee (26).

12.

Remove screw (23), washer (24), and tee (26) from differential housing cover (27).

13.

Disconnect hydraulic brake line (22) from flexible hydraulic brake line (17).

14.

Remove nut (21), lockwasher (20), and flexible hydraulic brake line (17) from bracket (19) on frame

rail (18). Discard lockwasher (20).

0161 00-2