 |
|||
|
|
|||
|
Page Title:
MASTER CYLINDER RESERVOIR REPLACEMENT - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-386-24-1-1
0156 00
MASTER CYLINDER RESERVOIR REPLACEMENT (Contd)
REMOVAL
.WARNING.
Accidental or intentional introduction of liquid contaminants into
the environment is in violation of state, federal, and military
regulations. Refer to Army POL (WP 0001 00) for information
concerning storage, use and disposal of these liquids. Failure to do
so may result in injury or death.
CAUTION
When disconnecting hydraulic lines and hoses, plug all openings
to prevent dirt and dust from entering and causing internal parts
damage. Remove caps and plugs prior to installation.
NOTE
Have drainage container ready to catch brake fluid.
1.
Loosen nut (5) and remove tube (6) with sleeve (4) from connector (3).
2.
Loosen nut (8) and remove tube (7) with sleeve (12) from elbow (13).
3.
Remove four screws (9), lockwashers (10), and master cylinder reservoir (2) from mounting
bracket (14). Discard lockwashers (10).
NOTE
Note position of elbow for installation.
4.
Remove elbow (13) and connector (3) from master cylinder reservoir (2).
NOTE
Assistant will help with step 5.
5.
Remove two locknuts (16), screws (11), and mounting bracket (14) from bracket (15) and
firewall (1). Discard locknuts (16).
INSTALLATION
1.
Apply sealant to male threads of elbow (13) and connector (3).
NOTE
Assistant will help with step 2.
2.
Install mounting bracket (14) on bracket (15) and firewall (1) with two screws (11) and new
locknuts (16).
3.
Install elbow (13) and connector (3) on master cylinder reservoir (2).
4.
Install master cylinder reservoir (2) on mounting bracket (14) with four new lockwashers (10) and
screws (9).
5.
Install tube (7) with sleeve (12) on elbow (13) and tighten nut (8).
6.
Install tube (6) with sleeve (4) on connector (3) and tighten nut (5).
7.
Bleed service brakes (WP 0154 00) and road test vehicle.
0156 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version