INTERMEDIATE PROPELLER SHAFT MAINTENANCE (M36A3) - continued

TM 9-2320-386-24-1-1

0148 00

INTERMEDIATE PROPELLER SHAFT MAINTENANCE (M36A3) (Contd)

REMOVAL

1. Chock two wheels on one side of vehicle and raise two rear wheels on opposite side of vehicle

(TM 9-2320-386-10).

2. Release parking brake (TM 9-2320-386-10).

NOTE

Mark propeller shaft flange positions for installation.

Rotate propeller shaft in step 3 to gain access to propeller shaft

mounting screws and locknuts.

3. Remove four locknuts (27) and screws (29) and separate flange (28) on rear intermediate propeller

shaft (30) from flange (11) on front intermediate propeller shaft (23). Discard locknuts (27).

4. Lower rear intermediate propeller shaft (30) and position out of way.

5. Remove cotter pin (8), nut (9), washer (10), flange (11), and deflector (12) from shaft (23). Discard

cotter pin (8).

NOTE

Assistant will help with step 6.

6. Remove two locknuts (16), washers (15), screws (7), propeller shaft (23), and bearing housing (18)

from frame support (4). Discard locknuts (16).

7. Remove four locknuts (25) from studs (1) and separate flange (24) from flange (26) in parking

brakedrum (2). Discard locknuts (25).

8. Remove four locknuts (3), screws (5), and frame support (4) from crossmember (6). Discard

locknuts (3).

DISASSEMBLY

1. Remove bearing housing (18) from propeller shaft (23).

2. Remove screw (22), lockwasher (21), and slide shield (20) from propeller shaft (23). Discard

lockwasher (21).

3. Remove two seals (13) and bearing (19) from bearing housing (18). Discard seals (13).

4. Remove four rubber insulators (14) from bearing housing (18).

NOTE

Perform step 5 if lubrication fitting is damaged.

5. Remove lubrication fitting (17) from bearing housing (18).

0148 00-2