PROPELLER SHAFT MAINTENANCE - continued - TM-9-2320-386-24-1-10665

TM 9-2320-386-24-1-1

0147 00

PROPELLER SHAFT MAINTENANCE (Contd)

ASSEMBLY

NOTE

Perform step 1 or 2 if lubrication fitting was removed.

Install lubrication fitting (11) in U-joint end of shaft (12).

Install lubrication fitting (18) in shaft (12).

Install new seal (13) in bore (17) of shaft (12).

Install cap (15) on shaft (16), with open side toward splined end of shaft, and slide cap (15) up

on shaft (16).

5. Install washer (14) on shaft (16).

6. Coat splines on shaft (16) with a thick film of GAA grease.

7. Slide splined end of shaft (16) through seal (13) and into internal splines of shaft (12).

8. Position washer (14) against seal (13) and install cap (15) on shaft (12).

INSTALLATION

1. Install flange (4) with propeller shaft (10) on studs (2) of flange (1) inside parking brakedrum (3)

with four new locknuts (5). Tighten locknuts (5) 102-121 lb-ft (138-164 Nm).

2. Install flange (7) with propeller shaft (10) on flange (8) with four screws (6) and new locknuts (9).

Tighten locknuts (9) 102-121 lb-ft (138-164 Nm).

3. Apply parking brake (TM 9-2320-386-10).

4. Lower wheels, and remove chocks (TM 9-2320-386-10).

5. Lubricate propeller shaft (WP 0023 00).

0147 00-4