 |
|||
|
|
|||
|
Page Title:
FRONT WHEEL DRIVE LOCK-IN SWITCH, AIR LINES, AND INDICATOR REPLACEMENT - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-386-24-1-1
0145 00
FRONT WHEEL DRIVE LOCK-IN SWITCH, AIR LINES, AND INDICATOR REPLACEMENT (Contd)
REMOVAL
.WARNING.
Do not disconnect air lines before draining air reservoirs. Small
parts under pressure may shoot out with high velocity, causing
injury to personnel.
Eyeshields must be worn when releasing compressed air. Failure
to do so may result in injury to personnel.
CAUTION
When disconnecting air lines and hoses, plug all openings to
prevent dirt from entering and causing damage to internal parts.
Remove all plugs prior to installation.
1.
Disconnect plug with lead 27A (16) from indicator housing (15).
2.
Disconnect plug with leads 27 and 27A (17) from pressure switch (19) on lock-in switch (18).
3.
Disconnect air line (2) from bulkhead fitting (1) on firewall (23) and elbow (20) on lock-in switch (18).
4.
Disconnect air supply line (22) from connector (21) on lock-in switch (18).
5.
Remove two screws (9), plate (8), and lock-in switch (18) from mounting bracket (7).
NOTE
Note position of elbow for installation.
6.
Remove elbow (20) and connector (21) from lock-in switch (18).
7.
Remove pressure switch (19) from lock-in switch (18).
8.
Remove lamp cover (11) and lamp (10) from indicator housing (15).
9.
Remove two screws (12), lockwashers (13), and indicator housing (15) from mounting bracket (7).
Discard lockwashers (13).
10.
Remove two nuts (4), four ground (GND) leads 57, 99d, 770d, and 117 (5), two lockwashers (6),
screws (14), and mounting bracket (7) from panel (3). Discard lockwashers (6).
0145 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version