 |
|||
|
|
|||
|
Page Title:
TRANSMISSION INTERNAL OIL FILTER MAINTENANCE - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-386-24-1-1
0143 00
TRANSMISSION INTERNAL OIL FILTER MAINTENANCE (Contd)
OIL FILTER REMOVAL
1.
Remove two screws (10) and lockwashers (11) from bracket (12), oil pan (8), and transmission (1).
Discard lockwashers (11).
2.
Remove nineteen screws (9), oil pan (8), and gasket (7) from transmission (1). Discard gasket (7).
3.
Remove screw (6), oil filter (5), oil filter tube (4), and O-ring (3) from control valve body (2) in
transmission (1). Discard O-ring (3).
4.
Remove oil filter tube (4) from oil filter (5). Discard oil filter (5).
5.
Disconnect transmission oil cooler hoses (13) and (15) from transmission external oil filter base (14).
.WARNING.
Eyeshields must be worn when releasing compressed air. Failure
to do this may result in injury to personnel.
CAUTION
Compressed air source will not exceed 60 psi (414 kPa). Doing so
may cause damage to internal components of the transmission.
6.
Using compressed air, drain remaining oil from external transmission oil cooler hoses (13) and (15).
CLEANING AND INSPECTION
.WARNING.
Volatile mineral spirits burn easily and fumes can explode. Do not
smoke or allow open flame nearby when using mineral spirits.
Failure to do so may cause serious injury or death to personnel.
1.
Clean oil pan (8) and oil pan magnet thoroughly with mineral spirits and dry with lint-free cloth.
2.
Inspect oil pan (8) for cracks. Replace oil pan (8) if cracked.
OIL FILTER INSTALLATION
1.
Connect transmission oil cooler hoses (13) and (15) to elbows (16) on transmission external
oil filter base (14).
2.
Replace transmission external oil filter (WP 0142 00).
3.
Install new O-ring (3) and oil filter tube (4) on new oil filter (5).
4.
Install oil filter tube (4) and new oil filter (5) on control valve body (2) in transmission (1) with
screw (6).
NOTE
Soak new gasket in lubricating oil for five minutes prior to
installation.
5.
Install new gasket (7) and oil pan (8) on transmission (1) with nineteen screws (9). Tighten
screws (9) 10-15 lb-ft (14-20 Nm).
6.
Install oil pan (8) and bracket (12) on transmission (1) with two new lockwashers (11) and
screws (10).
7.
Install transmission oil dipstick tube (WP 0138 00).
8.
Fill transmission oil to proper level (WP 0022 00).
0143 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version