 |
|||
|
|
|||
|
Page Title:
TRANSMISSION EXTERNAL OIL FILTER AND BASE REPLACEMENT - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-386-24-1-1
0142 00
TRANSMISSION EXTERNAL OIL FILTER AND BASE REPLACEMENT (Contd)
OIL FILTER REMOVAL
.WARNING.
Accidental or intentional introduction of liquid contaminants into
the environment is in violation of state, federal, and military
regulations. Refer to Army POL (WP 0001 00) for information
concerning storage, use and disposal of these liquids. Failure to do
so may result in injury or death.
NOTE
Have drainage container ready to catch oil.
Remove oil filter (8) from oil filter base (6). Discard oil filter (8).
OIL FILTER BASE REMOVAL
1.
Remove oil filter (8) (see oil filter removal).
2.
Disconnect oil inlet hose (4) and oil outlet hose (10) from elbows (5) and (9).
3.
Remove two locknuts (12), screws (1), and mounting bracket (2) with base (6) from frame rail (13).
Discard locknuts (12).
4.
Remove three locknuts (11), screws (3), and base (6) from mounting bracket (2). Discard
locknuts (11).
5.
Remove elbows (5) and (9) from base (6).
OIL FILTER BASE INSTALLATION
1.
Apply sealant to male threads of elbows (5) and (9).
2.
Install elbows (5) and (9) on base (6).
3.
Install base (6) on mounting bracket (2) with three screws (3) and new locknuts (11).
4.
Install mounting bracket (2) with base (6) on frame rail (13) with two screws (1) and new
locknuts (12).
5.
Connect oil inlet hose (4) and oil outlet hose (10) to elbows (5) and (9).
OIL FILTER INSTALLATION
1.
Coat new oil filter seal (7) with lubricating oil and install new oil filter (8) on oil filter base (6).
2.
Tighten oil filter (8) finger-tight, and then turn oil filter clockwise another 1/4-turn.
3.
Check transmission oil level and refill if necessary (WP 0022 00).
0142 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version