TRANSMISSION MODULATOR CONTROL CABLE MAINTENANCE - continued

TM 9-2320-386-24-1-1

0135 00

TRANSMISSION MODULATOR CONTROL CABLE MAINTENANCE (Contd)

REMOVAL

Remove screw (2), clamp (3), modulator (1), and packing retainer (4) from transmission (5). Discard

packing retainer (4).

Remove cotter pin (16), washer (15), and pivot (7) with modulator cable (10) from lever (6). Discard

cotter pin (16).

Remove locknut (9), screw (11), and modulator cable (10) from bracket (8). Discard locknut (9).

NOTE

Perform step 4 if replacement of pivot is necessary.

Loosen jamnut (12) and remove pivot (7) from modulator cable (10).

INSTALLATION

NOTE

Perform step 1 if pivot was removed.

Install pivot (7) on threaded end of modulator cable (10). Tighten jamnut (12).

Install new packing retainer (4) and modulator (1) on transmission (5) with clamp (3) and

screw (2). Finger-tighten screw (2).

Route modulator cable (10) to front of cab (14) and install on bracket (8) with screw (11) and new

locknut (9).

Install pivot (7) with modulator cable (10) in lever (6), and install washer (15) and new cotter

pin (16).

Tighten screw (2).

ADJUSTMENT

NOTE

Assistant will help with this procedure.

Check that accelerator cable is in full throttle position

when accelerator is fully depressed.

Perform step 1 if pivot was not removed.

Remove cotter pin (16), washer (15), and pivot (7) with modulator cable (10) from lever (6). Discard

cotter pin (16).

Direct assistant to depress accelerator to full throttle position.

Pull rod end (13) out of modulator cable (10) until full throttle position is achieved.

Install pivot (7) on lever (6).

a. If pivot (7) does not align with hole in lever (6), loosen jamnut (12) and adjust pivot (7) until

pivot (7) aligns with hole in lever (6) and tighten jamnut (12).

b. If pivot (7) aligns with hole in lever (6), install washer (15) and new cotter pin (16).

0135 00-2