 |
|||
|
|
|||
|
Page Title:
TRANSMISSION SHIFT TOWER REPLACEMENT - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-386-24-1-1
0133 00
TRANSMISSION SHIFT TOWER REPLACEMENT (Contd)
REMOVAL
1.
Remove four locknuts (6), screws (4), and shift tower (3) from cover (8) and cab tunnel (7). Discard
locknuts (6).
2.
Remove grommet (1) from cover (8) and pull harness (5) and shift cable (2) from cover (8).
3.
Remove two screws (15) and supports (9) and (11) from base (10).
NOTE
Perform step 4 if support requires replacement. Step applies to
vehicles without front winch only.
4.
Remove plug (12), two screws (13), and cover (14) from support (11).
INSTALLATION
NOTE
Perform step 1 if support was replaced. Step applies to vehicles
without front winch only.
1.
Install plug (12) on support (11).
2.
Install cover (14) on support (11) with two screws (13).
3.
Install supports (9) and (11) on base (10) with two screws (15).
4.
Insert harness (5) and shift cable (2) through hole in cover (8).
5.
Install grommet (1) in hole of cover (8).
6.
Install shift tower (3) on cover (8) and cab tunnel (7) with four screws (4) and new locknuts (6).
7.
Install cab insulation (WP 0201 00).
8.
Install transmission select lever (WP 0134 00)
9.
Install front winch controls, if equipped (WP 0223 00).
0133 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version