 |
|||
|
|
|||
|
Page Title:
WIPER MOTOR WIRING HARNESS REPLACEMENT - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-386-24-1-1
0127 00
WIPER MOTOR WIRING HARNESS REPLACEMENT (Contd)
NOTE
For additional wiring harness replacement information, refer to
WP 0386 00, Electrical System Wiring Diagram.
REMOVAL
NOTE
Tag all leads for installation.
1.
Disconnect wiper motor wiring harness lead 27 (9) from front wiring harness lead 400 (10).
2.
Remove two nuts (6), screws (11), lockwashers (8), and four ground (GND) terminals (7) from
instrument panel (12). Discard lockwashers (8).
3.
Disconnect lead 27 (15) from wiper motor switch (16).
4.
Remove screw (5), lockwasher (4), ground (GND) terminal (3), and lockwasher (2) from wiper motor
mounting bracket (1). Discard lockwashers (2) and (4).
5.
Remove grommet (13) from instrument panel (12) and wiper motor wiring harness (14).
CAUTION
Prior to removal of wiring harness, ensure all disconnections have
been performed. Failure to do so may result in damage to
equipment.
Use care when removing wiper motor wiring harness. Pulling a
snagged or attached harness from the vehicle may result in
damage to equipment.
6.
Remove wiper motor wiring harness (14) from vehicle.
INSTALLATION
NOTE
If new wiring harness is to be installed, transfer tags from old
harness to new harness.
If wiring harness requires repair, refer to WP 0125 00 for further
instructions.
1.
Insert wiper motor wiring harness (14) through hole in instrument panel (12).
NOTE
Wiring harness is engineered for each vehicle configuration.
Adjust wiring harness to remove slack or allow slack as required
for proper installation.
2.
Connect lead 27 (15) to wiper motor switch (16).
3.
Install new lockwasher (2), ground (GND) terminal (3), new lockwasher (4), and screw (5) on wiper
motor mounting bracket (1).
4.
Install grommet (13) on wiring harness (14) and instrument panel (12).
5.
Install four ground (GND) terminals (7) on instrument panel (12) with two screws (11), new
lockwashers (8), and nuts (6).
6.
Connect wiper motor wiring harness lead 27 (9) to front wiring harness lead 400 (10).
7.
Connect battery ground cable (WP 0121 00).
0127 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version