 |
|||
|
|
|||
|
Page Title:
REAR LIGHTING WIRING HARNESS REPLACEMENT - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-386-24-1-1
0126 00
REAR LIGHTING WIRING HARNESS REPLACEMENT (Contd)
INSTALLATION
NOTE
If new wiring harness is to be installed, transfer tags, applied
during removal, from old harness to new harness.
If wiring harness requires repair, refer to WP 0125 00 for further
instructions.
1.
Position rear lighting wiring harness (1) in vehicle.
NOTE
As rear lighting wiring harness is installed, remove clamps from
their tagged locations, then perform installation as specified for
each location.
Wiring harness is engineered for each vehicle configuration.
Adjust wiring harness to remove slack or allow slack as required
for proper installation.
2.
Install wiring harness (1) on panel (12) with clamp (2), two new lockwashers (10), screw (11), and
new locknut (3).
3.
Connect three leads 21 (4) to clearance marker light leads 489 (5).
4.
Connect leads 21 (6) and lead 380A (7) to plug 21 (9) and plug 380A (8).
5.
Connect lead 380A (16) to backup light plug 467 (15).
6.
Connect lead 21 (17) to clearance marker light plug 489 (18).
7.
Install wiring harness (1) on body (20) with clamp (14), screw (19), and new locknut (13).
8.
Connect lead 21 (25) to rear side marker light plug 489 (26).
9.
Install clamp (23) on side cargo bed rail (27) with screw (21), two new lockwashers (22), and new
locknut (24).
10.
Connect battery ground cable (WP 0121 00).
0126 00-4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version