 |
|||
|
|
|||
|
Page Title:
REAR LIGHTING WIRING HARNESS REPLACEMENT - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-386-24-1-1
0126 00
REAR LIGHTING WIRING HARNESS REPLACEMENT (Contd)
REMOVAL
NOTE
Tag all leads for installation.
For additional wiring harness replacement information,
refer to WP 0386 00, Electrical System Wiring Diagram.
Left and right side wiring is replaced basically the
same way. This procedure covers the left side.
1.
Disconnect lead 21 (5) from rear side marker light plug 489 (6).
2.
Remove locknut (4), two lockwashers (2), screw (1), clamp (3), and lead 21 (5) from side cargo bed
rail (7). Discard locknut (4) and lockwashers (2).
3.
Disconnect lead 21 (13) from clearance marker light plug 489 (15).
4.
Disconnect lead 380A (12) from backup light plug 467 (16).
5.
Remove locknut (9), screw (14), and clamp (10) from rear cargo body panel (8) and wiring
harness (11). Discard locknut (9).
6.
Disconnect three leads 21 (19) from clearance marker light leads 489 (20).
7.
Disconnect lead 21 (21) and lead 380A (22) from plugs 21 (24) and 380A (23).
8.
Remove locknut (18), screw (26), two lockwashers (25), and clamp (17) from panel (27) and wiring
harness (11). Discard locknut (18) and lockwashers (25).
CAUTION
Prior to removal of wiring harness, ensure all clips are removed
and disconnections have been performed. Failure to do so may
result in damage to equipment.
Use care when removing rear lighting wiring harness. Pulling a
snagged or attached harness from the vehicle may result in
damage to equipment.
9.
Remove rear lighting wiring harness (11) from vehicle.
0126 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version