 |
|||
|
|
|||
|
Page Title:
AIR HORN REPLACEMENT - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-386-24-1-1
0119 00
AIR HORN REPLACEMENT (Contd)
REMOVAL
WARNING
Do not disconnect air lines before draining air reservoirs. Small
parts under pressure may shoot out with high velocity, causing
injury to personnel.
Eyeshields must be worn when releasing compressed air. Failure
to do this may result in injury to personnel.
NOTE
Tag wires for installation.
1.
Disconnect wire plugs 25 and 26 (5) from air solenoid (4).
2.
Remove tiedown strap (13) from wiring harness (12) and horn (6). Discard tiedown strap (13).
3.
Disconnect air line (14) from elbow (3) on solenoid (4).
4.
Remove two locknuts (9), screws (2), bracket (8), and horn (6) from fender (1). Discard
locknuts (9).
5.
Remove two nuts (11), lockwashers (10), screws (7), and horn (6) from bracket (8). Discard
lockwashers (10).
6.
Remove elbow (3) from solenoid (4).
7.
Remove solenoid (4) from horn (6).
INSTALLATION
1.
Apply sealant to male threads of solenoid (4) and elbow (3).
2.
Install solenoid (4) on horn (6).
3.
Install elbow (3) on solenoid (4).
4.
Install horn (6) on bracket (8) with two screws (7), new lockwashers (10), and nuts (11).
5.
Install bracket (8) and horn (6) on fender (1) with two screws (2) and new locknuts (9).
6.
Connect air line (14) on elbow (3) on solenoid (4).
7.
Connect wire plugs 25 and 26 (5) on solenoid (4).
8.
Install wiring harness (12) on horn (6) with new tiedown strap (13).
9.
Connect battery ground cable (WP 0121 00).
10.
Start engine (TM 9-2320-386-10) and allow air pressure to build up to normal operating range.
Check for air leaks at horn and solenoid.
0119 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version