 |
|||
|
|
|||
|
Page Title:
BLACKOUT DRIVE LAMP AND HOUSING REPLACEMENT - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-386-24-1-1
0105 00
BLACKOUT DRIVE LAMP AND HOUSING REPLACEMENT (Contd)
LAMP REMOVAL
NOTE
Screws are not removable from lens cover.
1.
Loosen four screws (1) and remove lens cover (25) and gasket (24) from housing (2). Discard
gasket (24).
2.
Remove bulb (23) from housing (2).
LIGHT REMOVAL
1.
Remove two locknuts (14), screws (18), and rain cover (17) from bracket (16). Discard locknuts (14).
2.
Disconnect lead 24 (3) from housing (2).
3.
Remove nut (20), lockwashers (21) and (22), ground (GND) lead (6), housing (2), lockwasher (4),
finishing washer (5), and five washers (7) from mounting bracket (10). Discard lockwashers (21), (22),
and (4).
4.
Remove nut (8), screw (11), and clamp (9) from wiring harness (12) and mounting bracket (10).
5.
Remove two locknuts (19), screws (13), and mounting bracket (10) from front bumper (15). Discard
locknuts (19).
LIGHT INSTALLATION
1.
Install mounting bracket (10) on front bumper (15) with two screws (13) and new locknuts (19).
2.
Install wiring harness (12) on mounting bracket (10) with clamp (9), screw (11), and nut (8).
3.
Install five washers (7), new lockwasher (4), finishing washer (5), housing (2), and ground (GND)
lead (6) on mounting bracket (10) with new lockwashers (21) and (22) and nut (20).
4.
Connect lead 24 (3) to housing (2).
5.
Install rain cover (17) on bracket (16) with two screws (18) and new locknuts (14).
LAMP INSTALLATION
1.
Install bulb (23) on housing (2).
2.
Install new gasket (24) and lens cover (25) on housing (2) and tighten four screws (1).
3.
Connect battery ground cable (WP 0121 00).
4.
Check operation of blackout drivelight (TM 9-2320-386-10).
0105 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version