 |
|||
|
|
|||
|
Page Title:
FAN ACTUATOR TUBE MAINTENANCE - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-386-24-1-1
0086 00
FAN ACTUATOR TUBE MAINTENANCE (Contd)
REMOVAL
1.
Loosen nut (7) and remove fan actuator tube (2) with insert (8) from elbow (1).
2.
Loosen nut (13) and remove fan actuator tube (2) with insert (11) from fan actuator fitting (10).
3.
Remove screw (15) and clamp (14) from actuator tube (2) and bracket (9).
4.
Remove fan actuator tube (2) and grommets (3) and (5) from upper radiator shroud (4) and surge
tank support bracket (6).
INSPECTION
1.
Inspect fan actuator fitting (10), elbow (1), compression sleeve (12), inserts (8) and (11), and fan
actuator tube (2) for damage. Replace fan actuator fitting (10) or elbow (1) if tube inserts (8)
and (11) or compression sleeve (12) are damaged.
2.
Refer to WP 0167 00, Compressed Air Tubes Repair, if necessary.
INSTALLATION
1.
Install fan actuator tube (2) and grommets (5) and (3) in surge tank bracket (6) and upper radiator
shroud (4).
2.
Install fan actuator tube (2) with insert (8) on elbow (1) and tighten nut (7).
3.
Install fan actuator tube (2) with insert (11) on fan actuator fitting (10) and tighten nut (13).
CAUTION
Fan air actuator tube must hang loosely between surge tank
bracket and upper radiator shroud to prevent breakage.
NOTE
Ensure fan actuator tube has a 1/2-in. (12.7 mm) deflection
between clamp and fan actuator.
4.
Pull fan actuator tube (2) until one-half inch deflection is felt in fan actuator tube (2) at fan
actuator (10).
5.
Install fan actuator tube (2) on bracket (9) with clamp (14) and screw (15).
6.
Start engine (TM 9-2320-386-10). Allow air pressure to build up to normal operating air pressure.
Check fan for proper operation.
0086 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version