 |
|||
|
|
|||
|
Page Title:
FAN AND FAN CLUTCH REPLACEMENT - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-386-24-1-1
0082 00
FAN AND FAN CLUTCH REPLACEMENT (Contd)
REMOVAL
NOTE
Mark front of fan for proper installation.
1.
Remove six nuts (5), lockwashers (4), washers (3), and fan (2) from clutch (1). Discard
lockwashers (4).
2.
Install cylinder assembly (12) on actuator hub (6) with washer (13) and locknut (14).
3.
Install fan actuator tube (7) with sleeve (9) and insert (10) on fitting (11) and tighten nut (8).
4.
Disconnect air actuator tube (15) and reducer (16) from tee (17).
CAUTION
Compressed air source will not exceed 110 psi (758 kPa). When
applying compressed air to fan actuator, eyeshields must be worn.
Failure to do so may result in injury to personnel.
NOTE
Ensure engine temperature is below 180F (82C) prior to
applying air pressure to release clutch.
To gain access to clutch screws, 96-110 psi (662-758 kPa) of
compressed air must be applied to clutch to allow for free rotation
during removal.
5.
Apply air pressure to reducer (16) and turn clutch (1) until slots are aligned with screws (20).
6.
Loosen nut (8) and remove fan actuator tube (7), sleeve (9), and insert (10) from fitting (11).
7.
Remove locknut (14), washer (13), and cylinder assembly (12) from actuator hub (6). Discard
locknut (14).
8.
Remove six screws (20), clutch (1), and adapter plate (19) from fan mount (18).
9.
Connect reducer (16) and air actuator tube (15) to tee (17).
INSTALLATION
1.
Install
adapter plate (19) and clutch (1) on fan mount (18) with six screws (20).
2.
Install
fan (2) on clutch (1) with six washers (3), new lockwashers (4), and nuts (5).
3.
Install
fan drivebelt (WP 0084 00).
4.
Install
radiator (WP 0069 00).
5.
Install
fan actuator (WP 0085 00).
0082 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version