 |
|||
|
|
|||
|
Page Title:
ACCELERATOR CABLE MAINTENANCE - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-386-24-1-1
0064 00
ACCELERATOR CABLE MAINTENANCE (Contd)
INSTALLATION
1.
Route accelerator cable (10) through vehicle and position for installation.
2.
Install accelerator support bracket (21) on firewall (23) with screw (22) and new locknut (24).
3.
Install accelerator cable (10) on accelerator support bracket (21) with screw (20) and new
locknut (30).
NOTE
Ensure jamnut is centered on threads of accelerator cable prior to
installing accelerator cable clevis and sleeve.
4.
Install accelerator cable clevis (27) on accelerator cable (10) until accelerator cable clevis (27)
touches jamnut (29).
5.
Install sleeve (15) on accelerator cable (10) until sleeve (15) touches jamnut (11).
6.
Install accelerator cable clevis (27) on bellcrank (25) with pin (26) and new cotter pin (28).
NOTE
Ensure lock support is positioned to avoid interference with
accelerator cable movement.
7.
Install accelerator cable (10) and throttle cable (5) on lock support (7).
8.
Install lock support (7) on cable support (9) with two screws (6) and new locknuts (8).
9.
Install throttle bracket (17) and ball joint (16) on throttle lever (14) with new lockwasher (13) and
nut (12).
10.
Pull sleeve (15) back on accelerator cable (10) and install accelerator cable (10) on ball joint (16).
11.
Position throttle cable (5) through pivot (4) and install pivot (4) on throttle bracket (17) with new
cotter pin (19).
12.
Install stop collar (2) on throttle cable (5) with screw (3).
13.
Install spring (1) on anchor (18) and throttle bracket (17).
ADJUSTMENT
1.
Loosen screw (3) securing stop collar (2) to throttle cable (5).
2.
Remove nut (12), lockwasher (13), throttle bracket (17), spring (1), and accelerator cable (10) from
throttle lever (14). Discard lockwasher (13).
3.
Remove cotter pin (28), pin (26), and accelerator cable (10) from bellcrank (25). Discard cotter
pin (28).
4.
Loosen jamnuts (11) and (29) on accelerator cable (10).
NOTE
Ensure accelerator cable is fully extended towards throttle lever
prior to adjusting.
5.
Shorten or lengthen clevis (27) until holes in clevis (27) and bellcrank (25) align.
6.
Shorten or lengthen sleeve (15) until balljoint (16) aligns with hole in throttle lever (14).
7.
Tighten jamnuts (11) and (29) on accelerator cable (10).
8.
Install accelerator cable (10) on bellcrank (25) with pin (26) and new cotter pin (28).
9.
Install accelerator cable (10), throttle bracket (17), and spring (1) on throttle lever (14) with new
lockwasher (13) and nut (12).
10.
With accelerator in idle position, remove excess play in throttle cable (5) by sliding stop collar (2) to
pivot (4) and tighten screw (3).
0064 00-4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version