 |
|||
|
|
|||
|
Page Title:
ACCELERATOR PEDAL AND BRACKETS REPLACEMENT - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-386-24-1-1
0063 00
ACCELERATOR PEDAL AND BRACKETS REPLACEMENT (Contd)
REMOVAL
1.
Remove cotter pin (9), pin (7), and accelerator cable clevis (8) from bellcrank (5). Discard cotter
pin (9).
2.
Remove accelerator cable (10) from accelerator support bracket (12) and remove locknut (11),
screw (2), and accelerator support bracket (12) from anchor (1). Discard locknut (11).
3.
Remove locknut (6), screw (4), and anchor (1) from cab floor (3). Discard locknut (6).
4.
Remove locknut (22) and slide modulator cable (16) from swivel (21). Discard locknut (22).
5.
Remove two cotter pins (24), washers (23), swivel (21), and rod (13) from lever (20). Discard cotter
pins (24).
6.
Remove cotter pin (17), pin (19), and lever (20) from bracket (18). Discard cotter pin (17).
7.
Remove two screws (15), lockwashers (14), and bracket (18) from cab floor (3). Discard
lockwashers (14).
8.
Remove cotter pin (25), washer (26), and rod (13) from accelerator pedal (27). Discard cotter pin (25).
9.
Remove pin (29) and accelerator pedal (27) from accelerator pedal bracket (28).
10.
Remove two locknuts (32), screws (30), anchor (31), and accelerator pedal bracket (28) from cab
floor (3). Discard locknuts (32).
11.
Remove locknut (33), screw (34), and modulator cable (16) from anchor (31). Discard locknut (33).
INSTALLATION
1.
Install modulator cable (16) on anchor (31) with screw (34) and new locknut (33).
2.
Install anchor (31) and accelerator pedal bracket (28) on cab floor (3) with two screws (30) and new
locknuts (32).
3.
Install accelerator pedal (27) on accelerator pedal bracket (28) with pin (29).
4.
Install rod (13) on accelerator pedal (27) with washer (26) and new cotter pin (25).
5.
Install bracket (18) on cab floor (3) with two new lockwashers (14) and screws (15).
6.
Install lever (20) on bracket (18) with pin (19) and new cotter pin (17).
7.
Install swivel (21) and rod (13) on lever (20) with two washers (23) and new cotter pins (24).
8.
Insert modulator cable (16) through swivel (21) and install new locknut (22) on modulator cable (16).
9.
Install anchor (1) on cab floor (3) with screw (4) and new locknut (6).
10.
Install accelerator support bracket (12) on anchor (1) with screw (2) and new locknut (11). Install
accelerator cable (10) on accelerator support bracket (12).
11.
Install accelerator cable clevis (8) on bellcrank (5) with pin (7) and new cotter pin (9).
12.
Position accelerator pedal (27) to full travel and pull modulator cable (16) to full stop position and
tighten locknut (22) up to swivel (21).
0063 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version