 |
|||
|
|
|||
|
Page Title:
THROTTLE CONTROL CABLE REPLACEMENT - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-386-24-1-1
0062 00
THROTTLE CONTROL CABLE REPLACEMENT (Contd)
REMOVAL
1.
Remove spring (17) from brackets (10) and (16).
2.
Remove screw (14), washer (13), clamp (15) with air compressor coolant line (12), and bracket (16)
from engine (9).
3.
Remove screw (2) and stop collar (1) from throttle cable (4).
4.
Remove two locknuts (7) and screws (5) from lock support (6). Discard locknuts (7).
5.
Slide lock support (6) to the right and lift throttle cable (4) from cable support (8).
6.
Slide throttle cable (4) through pivot (3).
7.
Remove cotter pin (11) and pivot (3) from bracket (10). Discard cotter pin (11).
8.
Loosen nut (23) on throttle control (24).
9.
Remove setscrew (21) and handle (22) from throttle control (24).
10.
Remove nut (23), O-ring (20), and lockwasher (19) from throttle control (24).
11.
Push throttle control (24) through hole in instrument panel (18).
12.
Grasp throttle control (24), and remove cable (4) from below instrument panel (18) and through
hole in firewall.
INSTALLATION
NOTE
Perform steps 1 and 2 if installing new throttle cable.
1.
Remove setscrew (21) and handle (22) from new cable (4).
2.
Remove nut (23), O-ring (20), and lockwasher (19) from throttle control (24).
3.
Insert engine end of control cable (4) through hole in firewall and align on cable support (8).
4.
Insert throttle control (24) from behind instrument panel (18) through hole in instrument panel (18).
5.
Install lockwasher (19), O-ring (20), and nut (23) on throttle control (24).
6.
Thread cable (4) through pivot (3) and stop collar (1).
7.
Install handle (22) on throttle control (24) with setscrew (21).
8.
Install bracket (16) and clamp (15) with air compressor coolant line (12) on engine (9) with
washer (13) and screw (14).
9.
Install pivot (3) on bracket (10) with new cotter pin (11).
NOTE
Assistant will help with step 10.
10.
Adjust length of throttle cable (4) and install screw (2) in stop collar (1) to secure cable (4).
11.
Install throttle cable (4) on cable support (8), align lock support (6) on with cable support (8), and
install two screws (5) and new locknuts (7).
12.
Install spring (17) on brackets (10) and (16).
0062 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version