QUICK-START TUBES REPLACEMENT (BUILT AFTER SERIAL NO. 504923) - continued

TM 9-2320-386-24-1-1

0060 00

QUICK-START TUBES REPLACEMENT (BUILT AFTER SERIAL NO. 504923) (Contd)

.WARNING.

Ether is extremely flammable. Perform this procedure in a well-

ventilated area away from flames and sparks. Failure to do so

may result in injury to personnel.

REMOVAL

Remove screw (6), washer (7), clamp (8), atomizer tee (13), and plate (12) from valve cover (17).

Loosen two nuts (2) and remove tubes (1) with sleeves (3) and inserts (4) from atomizers (5).

Loosen two nuts (9) and remove tubes (1) with sleeves (10) and inserts (11) from atomizer tee (13).

Remove three tiedown straps (20) securing tube (21) and jumper harness (22) to steering

column (18). Discard tiedown straps (20).

5. Loosen two nuts (16) and remove tube (21) with two sleeves (15) and inserts (14) from atomizer

tee (13), elbow (23), and chafeguard (19).

INSTALLATION

1. Install tube (21) and jumper harness (22) inside chafeguard (19).

2. Install tube (21) with two sleeves (15) and inserts (14) on atomizer tee (13) and elbow (23) and

tighten two nuts (16).

3. Using three new tiedown straps (20), secure chafeguard (19) with tube (21) and jumper harness (22)

to steering column (18).

4. Install tube (1) with two sleeves (10) and inserts (11) on atomizer tee (13) and tighten two nuts (9).

5. Install tube (1) with two sleeves (3) and inserts (4) on atomizers (5) and tighten two nuts (2).

6. Install plate (12), atomizer tee (13), and clamp (8) on valve cover (17) with washer (7) and screw (6).

0060 00-2