 |
|||
|
|
|||
|
Page Title:
QUICK-START CYLINDER, VALVE, AND JUMPER HARNESS REPLACEMENT (BUILT AFTER SERIAL NO. 504923) - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-386-24-1-1
0059 00
QUICK-START CYLINDER, VALVE, AND JUMPER HARNESS REPLACEMENT (BUILT AFTER SERIAL
NO. 504923) (Contd)
.WARNING.
Ether is extremely flammable. Perform this procedure in a well-
ventilated area away from flames and sparks. Failure to do so
may result in injury to personnel.
REMOVAL
1.
Disconnect jumper harness plug with leads 569A and 569B (8) from quick-start valve lead
connector (9).
2.
Loosen wingnut (21) and clamp (22) on cylinder (1).
3.
Remove (turn counterclockwise) cylinder (1) from quick-start valve (15) and remove cylinder (1)
from clamp (22).
4.
Remove gasket (18) from quick-start valve (15) if cracked or damaged. Discard gasket (18).
5.
Install plug with chain (16) on quick-start valve (15).
6.
Loosen nut (10) and remove tube (12) with sleeve (11) and insert (13) from elbow (14).
7.
Remove two screws (17), plug with chain (16), clamp (19), and quick-start valve (15) from
bracket (20).
NOTE
Note position of elbow for installation.
8.
Remove elbow (14) from quick-start valve (15).
9.
Disconnect jumper harness plug with leads 569A and 569B (5) from harness connector (6).
10.
Remove three tiedown straps (2) from chafeguard (3) and steering column (4).
11.
Remove jumper harness (7) from chafeguard (3).
INSTALLATION
1.
Install jumper harness (7) in chafeguard (3).
2.
Install chafeguard (3) on steering column (4) with three new tiedown straps (2).
3.
Connect jumper harness plug with leads 569A and 569B (5) to harness connector (6).
4.
Apply sealant to pipe threads on elbow (14) and install elbow (14) on quick-start valve (15).
5.
Install quick-start valve (15), clamp (19), and plug with chain (16) on bracket (20) with two
screws (17).
6.
Install tube (12) with sleeve (11) and insert (13) on elbow (14) and tighten nut (10).
7.
Remove plug with chain (16) from quick-start valve (15) and install plug with chain (16) on
clamp (19).
8.
If removed, install new gasket (18) on quick-start valve (15).
9.
Insert cylinder (1) through clamp (22) and install (turn clockwise) on quick-start valve (15).
10.
Tighten wingnut (21) and clamp (22) on cylinder (1).
11.
Connect jumper harness plug with leads 569A and 569B (8) to quick-start valve lead connector (9).
12.
Connect battery ground cable (WP 0121 00).
0059 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version