 |
|||
|
|
|||
|
Page Title:
FUEL/WATER SEPARATOR AND BRACKET REPLACEMENT - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-386-24-1-1
0053 00
FUEL/WATER SEPARATOR AND BRACKET REPLACEMENT (Contd)
REMOVAL
1.
Loosen nuts (4) and (3) and remove fuel inlet line (1) and fuel outlet line (2) from tee (18) and
elbow (7).
2.
Disconnect pressure transducer plug (19) from STE/ICE-R wiring harness receptacle (20).
3.
Remove two flange nuts (5), screws (10), washers (9), and fuel/water separator (8) from filter
bracket (12).
4.
Remove two screws (13) and filter bracket (12) from engine (11).
5.
Remove elbow (7) from fuel/water separator (8).
6.
Remove two O-rings (6) from elbow (7). Discard O-rings (6).
7.
Remove pressure transducer (15) from elbow (16).
8.
Remove elbow (16) and connector (17) from tee (18).
9.
Remove tee (18) from fuel/water separator (8).
10.
Remove three O-rings (14) from tee (18). Discard O-rings (14).
INSTALLATION
1.
Install three new O-rings (14) on tee (18).
2.
Install tee (18) on fuel/water separator (8).
3.
Apply sealant to threads of elbow (16) and install elbow (16) and connector (17) on tee (18).
4.
Install two new O-rings (6) on elbow (7).
5.
Install elbow (7) on fuel/water separator (8).
6.
Apply sealant to threads of pressure transducer (15) and connect pressure transducer (15) to
elbow (16).
7.
Install filter bracket (12) on engine (11) with two screws (13).
8.
Install fuel/water separator (8) on filter bracket (12) with two washers (9), screws (10), and flange
nuts (5).
9.
Connect pressure transducer plug (19) to STE/ICE-R wiring harness receptacle (20).
10.
Install fuel inlet line (1) to tee (18) and fuel outlet line (2) to elbow (7) and tighten nuts (4) and (3).
11.
Install fuel filter (WP 0054 00).
12.
Connect battery ground cable (WP 0121 00).
0053 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version