 |
|||
|
|
|||
|
Page Title:
ENGINE CRANKCASE BREATHER AND BASE MAINTENANCE - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-386-24-1-1
0029 00
ENGINE CRANKCASE BREATHER AND BASE MAINTENANCE (Contd)
REMOVAL
1.
Remove screw (8), washer (7), clamp (6), breather tube (5), and spacer (16) from engine (12).
2.
Remove clamp (4) and breather tube (5) from crankcase breather (3).
3.
Remove screw (1), washer (2), crankcase breather (3), and O-ring (19) from base (14). Discard
O-ring (19).
4. Remove plug (18) and O-ring (17) from base (14). Discard O-ring (17).
5. Remove two screws (9), washers (15), screws (10), washers (11), base (14), and gasket (13) from
engine (12). Discard gasket (13).
CLEANING
.WARNING.
Skysol-100 mixture is combustible. Use mechanical ventilation whenever
product is used in a confined space, is heated above ambient
temperatures, or is agitated. DO NOT use or store near heat, sparks,
flame, or other ignition sources. Keep container sealed when not in use.
Contact with Skysol-100 may cause skin irritation. Use chemical resistant
gloves. In case of skin contact, remove any contaminated clothing and
wash skin thoroughly with soap and water. Wash contaminated clothing
before reuse. Eye contact may cause irritation, tearing, or blurring of
vision. Use face shield or goggles when eye contact may occur. In case of
eye contact, flush eyes with large amounts of water for at least fifteen (15)
minutes or until irritation subsides. Inhalation may cause irritation to
upper respiratory passages. DO NOT have food or drink in the vicinity.
Clean crankcase breather (3) with Skysol-100 and dry with clean rag.
INSTALLATION
1.
Install new gasket (13) and base (14) on engine (12) with two washers (11), screws (10),
washers (15), and screws (9).
2.
Install new O-ring (17) and plug (18) on base (14).
3.
Apply lubricating oil to new O-ring (19).
4.
Install O-ring (19) and crankcase breather (3) on base (14) with washer (2) and screw (1).
5.
Install breather tube (5) on crankcase breather (3) with clamp (4).
6.
Install breather tube (5) and spacer (16) on engine (12) with clamp (6), washer (7), and screw (8).
7.
Start engine (TM 9-2320-386-10) and check for leaks.
0029 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version