 |
|||
|
|
|||
|
Page Title:
VALVE COVER REPLACEMENT - continued |
|
||
| ||||||||||
|
|
 TM 9-2320-386-24-1-1
0028 00
VALVE COVER REPLACEMENT (Contd)
IN-VEHICLE PREP
1.
Remove two clamps (6) and elbows (7) from air inlet elbows (5).
2.
Remove clamp (3) and adapter (2) from tube (4).
3.
Remove two tube assemblies (1) from vehicle.
REMOVAL
Remove fourteen screws (9), washers (10), valve cover (8), and gasket (11) from air intake manifold (12).
Discard gasket (11).
INSTALLATION
1.
Apply adhesive on new gasket (11) and position gasket (11) on valve cover (8).
2.
Install valve cover (8) on air intake manifold (12) with fourteen washers (10) and screws (9).
Tighten screws (9) 3-7 lb-ft (4-10 Nm) in sequence shown.
IN-VEHICLE FINISHING
1.
Position two tube assemblies (1) in vehicle.
2.
Install adapter (2) on tube (4) with clamp (3).
3.
Install two elbows (7) on air inlet elbows (5) with clamps (6).
4.
Install quick-start atomizers (WP 0057 00).
5.
Connect battery ground cable (WP 0121 00).
0028 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for a printable version