OIL FILTERS - TM-9-2320-386-24-1-10173

TM 9-2320-386-24-1-1

0023 00

OIL FILTERS

Oil

filters shall be changed as applicable, when:

(1)

They are known to be contaminated or clogged.

(2)

Service is recommended by AOAP laboratory analysis:

(3)

Prescribed hard-time intervals are reached.

AOAP REQUIREMENTS

(1) Engine oil, transmission oil, and hydraulic fluids must be sampled at 60 days or 1,000 miles

(1,609 km). Reserve and National Guard units should perform oil sampling every 120 days or 1,000 miles

(1,609 km) as prescribed by TB 43-0106 Aeronautical Equipment Army Oil Analysis Program (AOAP), or

DA Pam 738-750, Functional User Guide for the Army Maintenance Management System (TAMMS).

(2) In the event AOAP laboratory support is not available, use on-condition (OC) hard-time intervals will

be applied.

CLEANING

.WARNING.

Skysol-100 mixture is combustible. Use mechanical ventilation

whenever product is used in a confined space, is heated above

ambient temperatures, or is agitated. DO NOT use or store near

heat, sparks, flame, or other ignition sources. Keep container

sealed when not in use.

Contact with Skysol-100 may cause skin irritation. Use chemical

resistant gloves. In case of skin contact, remove any contaminated

clothing and wash skin thoroughly with soap and water. Wash

contaminated clothing before reuse. Eye contact may cause

irritation, tearing, or blurring of vision. Use face shield or goggles

when eye contact may occur. In case of eye contact, flush eyes

with large amounts of water for at least fifteen (15) minutes or

until irritation subsides. Inhalation may cause irritation to upper

respiratory passages. DO NOT have food or drink in the vicinity.

Keep all lubricants in closed container and store in clean, dry

place, away from extreme heat. Failure to do so may result in

injury to personnel.

CAUTION

Keep container covers clean and allow no dust, dirt, or other

foreign material to mix with lubricants. Keep all lubrication

equipment clean and ready to use.

(1) Keep all external parts of equipment not requiring lubrication free of lubricants.

(2) Before lubricating equipment, clean fittings. Use a biodegradable Skysol-100 to wipe all lubrication

points free of dirt and grease and dry before lubricating. After servicing lubrication points, wipe off excess

lubricants to prevent accumulation of foreign matter.

0023 00-2